US
SPRAY NOZZLE SELF CLEANING FILTER (MEDIUM, BIG FLOW RATE)
MAIN TECHNICAL FEATURES:
- Filtration degree from 2000 to 25 μm on polyester mesh/ AISI316
- Minimum amount discharge water
APPLICATIONS
- Prefiltration for water treatment plants
- Evaporation towers
- Spray nozzle protection
- Heat exchangers
HOW IT WORKS
Water enters the filter through the (1) inlet and goes through the filtering cylinder from the inside to the outside. This will retain all suspended solids that are the same size or bigger than the filtration degree installed. Filtered water leaves through the outlet pipe (2).
REGENERATION
When the differential pressure gauge reaches the pre-set pressure difference between filter inflow and
outflow, a signal is triggered and the cleaning starts. This operation is divided into three separate
phases:
The first phase is the closure of the inlet valve (1) with consequent closure of the outflow check valve (2)
In the second phase the vessel is emptied through the discharge valve (3)
The third phase is the actual cleaning: the washing inlet valve opens (4) and through the manifold (5)
feeds the nozzles (6), at the same time the electric motor (7) powers the rotations of the cleaning
systems. The washing pressure range from a minimum of 2 Bar to maximum of 10 Bar. Average length
of the cleaning cycle is 120 sec.
CONTROL
A switchboard controls the washing phases. The signal that starts the cleaning cycle is given by a differential pressure switch or by time. The switchboard gives an “alarm” signal in case of problems in the washing system. These signals can be sent to a pre-existing control center. The washing phase can also be controlled manually. The solenoids controlling the valves are pneumatic.
DO YOU NEED HELP?
FORM CONTATTI
CONTACTS
- (+39) 0521 806846
- info@elfifiltration.com
- Via Scodoncello n. 41/E – 43044, Collecchio, Parma
HOURS
- Monday- Friday
- 8.00 - 12.30 / 13.00 - 17.00